DECOR IN FRESHWATER TANKS
Rocks
Rocks suitable for use as decorative elements in an aquarium can be found in
natural settings or in specialist stores. Make sure they have no excessively sharp
splinters: sand them down to ensure that the fish do not get injured when in contact
with them.
Decor based on plant material: peat-bog roots and willow
branches.
How can you recognize a calcareous rock? By repeating a tried and tested experiment
that some of us performed in school: pour a few drops of vinegar or acid onto the
rock. If a slight effervescence does occur, which is caused by the release of carbon
dioxide, this means that the rock contains calcium. The same method can also be
used to test sand.
Rocks can be taken from natural settings, but they are also
available in the aquarium trade.
Wooden materials
The natural environments of our fish often contain more vegetation than rocks:
roots, branches that have fallen into the water, bark, and plants that become submerged
in the rainy season.
When used alone or with a rock, wood creates a beautiful decorative effect, especially
if it also plays host to moss or ferns.
Wood can be held in place by screwing it to a small stone
base.
It is therefore logical to use wood in an aquarium, but it must be treated first.
Wooden materials have two major disadvantages. Firstly, they release acid substances
that turn the water a yellowish amber color. Although this is no problem for Amazonian
aquariums, this is not really the case in waters that have to be kept hard. Secondly,
wood is light and must be wedged or weighed down.
Treating wood before putting it into the aquarium
The treatment aims to:
- free the wood of all animate material, especially those found in a natural
setting: bacteria, fungi, and other undesirable organisms;
- help water penetrate the piece to make it heavier;
- free it of most of its acid substances and colorings.
First brush down the wood carefully, then disinfect it by soaking it for 48 hours
in:
- either bleach (1 ml/4 liters of water, using a concentrated sachet);
- or copper sulfate, at 1 g/liter.
Then boil the wood, replacing the water several times. If the latter is colored,
this is proof that the acids are leaving the wood. Ideally, the treatment should
be concluded by keeping the wood submerged for 1 or 2 weeks, so that it gradually
fills up with water.
This is, however, often insufficient: the wood may still float and have to be
wedged into the aquarium with a few rocks. You can otherwise also weigh it down
with small stones attached by a nylon line that is all but invisible in the water,
hiding this part of the wood in the sediment or else among other rocks on the bottom.
|
